Contact us

info@huumsauna.com

DROP installation

Support

Open Menu
Enne ostmist
Paigaldamine
Mobiilirakendus
Kasutamine
Tõrked

DROP installation

DROP installation video

Check before installation
  1. Check if the power of the main fuse matches the parameters of the heater.
  2. Does the output (kW) of the heater match the volume (m3) of the sauna room? In case there are any uninsulated brick, tile, glass or log walls in the sauna room, an additional volume of 1.5 mshould be added to the sauna room for each square meter of such wall.
Positioning the heater

  • DROP stove should be positioned on the wall close enough to the sauna bench so that you can easily throw water on the stones from the bench. The top layer of stones should be at the level of your feet when you are sitting on the sauna bench.
  • Check Table 1 for minimal safety distances between the heater and the sauna room’s ceiling and walls.
  • Pay attention to placing the heater in a way that prevents dangerous situations during its use. Make sure people do not have to pass it too close when it is hot.
  • Before installation removes the protective film from the steel plate behind the heater.
  • When installing the wall mount, consider the full weight of 143 lb / 65 kg.
Connecting the heater to the power supply
  • Only a certified electrician is allowed to connect the heater to the power supply!
  • The main cable input is located in the center of the heater, 10 cm above the lower edge.
  • A rubber insulated HO7RN-F cable or an equivalent must be used as the power cable. It is forbidden to use a non-heat-resistant cable with PVC isolation.
  • The joint box must be waterproof and it must be located up to 50 cm from the floor.
  • We recommend connecting the unit to the mains without an earth-leakage circuit breaker.
  • Check Table 2 for the maximum current intensity in the cross-sectional area of the cable and circuit breaker.

  • Open the cover of the heater’s electrical box.
  • Attach the power cable on the terminal block according to the circuit diagram.
  • Close the cover.
  • Fix the cable on the output with a cable strap.
  • Install the heater on the wall frame. Make sure it remains securely attached to the wall.
Stones
  • DROP heater requires 121 lb / 55 kg of 2-3.9 in / 5-10 cm stones.
  • Read more about how to stack the stones correctly.
Was that article useful?

Become a reseller

Interested in becoming a HUUM dealer? Fill out this form, and we will review your information and contact you to discuss a potential new partnership.



    Contact form